Software module for engine control unit Delphi Gen1 CAN vehicles Toyota.
Module for virtual reading and writing of Toyota, Lexus, Scion, Hino vehicles' control units with Denso and Fujitsu Ten Gen1 based on NEC 76F0004/15/23/38/39/40/70/85 processors.
Supported vehicles and control units by Bitbox module for Toyota Delphi Gen1 CAN:
FIDs: 24, 26
- Toyota Denso NEC 76F00XX (FID: 24)
- Toyota Denso NEC TCM 76F00XX (FID: 26)
Supports working with Denso control units using CAN bus based on NEC 76F0038, 76F0039, 76F0040, 76F0070, and 76F0085 processors.
The module allows:
- Software version identification
- Virtual reading of the current or latest firmware version*
- Writing (both updates and downgrades)
- Checksum and CVN correction
- Recovery from any state**
* - Virtual reading mode selection is performed in the Settings section.
** - This function allows recovering control units that have been software-damaged by any flasher during CAN bus writing or during an update using Techstream. It does not require any additional JTAG/NBD equipment and can be performed using a J2534 device via the CAN bus in boot mode. This allows painlessly recovering control units, including LC200 4.5TD without complex disassembly to access the backside of the board, as well as units with no NBD/JTAG port pad (e.g., Camry V50, Highlander 3.5 U50, etc.).
To use the module, the purchase of a Bitbox USB protection key is required. The key can be purchased in our store. You can buy an unlimited number of modules with one key.
Module activation is done within 1 hour on business days (usually 10-15 minutes). Activation may be delayed during weekends and holidays (up to 2 hours).
To activate the module, ONLY the serial number of the key and email are required.
To work through the OBD2 connector, a J2534 adapter is required (Scanmatik 2, OpenPort 2.0, Dialink, Mongoose, etc.). More information about J2534 here.
To connect the control unit on the bench, additional equipment from the following list is required:
Powerbox and Combibox for PCMflash are fully compatible with Bitbox.An activated module or license cannot be returned.
If you have entered the wrong key or device number, the return is not valid. It is not possible to modify the license for another device.
After status update to "Waiting for activation", the data has already been sent to the developer for activation. The order cannot be canceled or corrected starting from this status update.
Pay attention to all information specified in the description of modules and scripts taken from the manufacturer. We are not responsible if the information is not correct or there are some differences from the reality. In the disputed situation, it is necessary to look for a solution to the issue to the manufacturer.
Our store is not responsible for the functionality of the software module. We cannot guarantee the declared functions since we are not the developer.