Software module for engine control unit Delphi CAN diesel vehicles Mercedes.
Module for reading and writing through the diagnostic connector and on the bench of Delphi CRD control units installed in Mercedes-Benz diesel vehicles.
Which vehicles and control units are supported by Bitbox MB Delphi Diesel CAN module:
FIDs: 197, 214, 216, 217, 218, 254
MB Delphi CRD3.xx TC1797 (FID: 214)
The family supports work with Delphi CRD3.xx control units based on Infineon Tricore TC1797 processor with 4MB internal memory.
Enables reading and writing through the CAN bus. Checksum correction is done during writing.
MB Delphi CRD3.xx TC1793 (FID: 197)
The family supports work with Delphi CRD3.xx control units based on Infineon Tricore TC1793 processor with 4MB internal memory.
Enables reading and writing through the CAN bus. Checksum correction is done during writing.
MB Delphi CRD3.xx TC1793 BENCH (FID: 254)
The family is for working on the bench with Delphi CRD3.xx control units for 2020 vehicles.
Enables reading and writing through the CAN bus on the bench. Checksum correction is done during writing. Requires DrewTech CarDAQ+, Scanmatik SM2 Pro, or other J2534 supporting 800 kbit/sec CAN speed.
Infiniti Delphi CRD3.xx (FID: 218)
The family supports work with Delphi CRD3.xx control units based on Infineon Tricore TC1797 processor with 4MB internal memory.
Enables reading and writing of calibration area through the CAN bus. Checksum correction is done during writing.
MB Delphi CRD2.xx (FID: 217)
The family supports work with Delphi CRD2.xx control units based on MPC5566 processor with 3MB internal memory.
Enables reading and writing through the CAN bus. Checksum correction is done during writing.
MB Delphi CRD.11 (FID: 216)
The family supports work with Delphi CRD.11 control units based on MPC563 processor with external memory and a total capacity of 2.5MB.
Enables reading and writing through the CAN bus. Checksum correction is done during writing. If writing on the vehicle is not possible, use bench connection.
To use the module, the purchase of Bitbox USB protection key Bitbox is required. The key can be purchased in our store. You can buy an unlimited number of modules with one key.
Module activation is done within 1 hour on business days (usually 10-15 minutes). Activation may be delayed during weekends and holidays (up to 2 hours).
For module activation, ONLY the serial number of the key and email are required.
To work through the OBD2 connector, a J2534 adapter is required (Scanmatik 2, OpenPort 2.0, Dialink, Mongoose, etc.). More information about J2534 here.
To connect the control unit on the bench, the purchase of additional equipment is required, any of the following:
Powerbox and Combibox for PCMflash are fully compatible with Bitbox.
An activated module or license cannot be returned.
If you have entered the wrong key or device number, the return is not valid. It is not possible to modify the license for another device.
After status update to "Waiting for activation", the data has already been sent to the developer for activation. The order cannot be canceled or corrected starting from this status update.
Pay attention to all information specified in the description of modules and scripts taken from the manufacturer. We are not responsible if the information is not correct or there are some differences from the reality. In the disputed situation, it is necessary to look for a solution to the issue to the manufacturer.
Our store is not responsible for the functionality of the software module. We cannot guarantee the declared functions since we are not the developer.