![Module Bosch MEDC17 BENCH [SM2/SM3 ONLY] (BitBox)](https://iobd.io/image/cache/wp/gp/products/bitbox/Bosch%20MEDC17%20Bench-100x100.webp)
![Module Bosch MEDC17 BENCH [SM2/SM3 ONLY] (BitBox)](https://iobd.io/image/cache/wp/gp/products/bitbox/Bosch%20MEDC17%20Bench-1000x1000.webp)
Software Universal module for bench reading and writing for Bosch ME(D)17 and EDC17 ECUs based on Infineon TC17xx.
Allows reading and writing flash and EEPROM on the bench with auto detection of MCU type and file size by using Bosch Service Mode (BSM). Checksum fix is performed on writing. No open ECU needed. Connection is only on the bench.
Which vehicles and control units does the Bitbox Bosch MEDC17 Bench module support: FID: 407
Supported MCUs: TC1724, TC1728, TC1762, TC1766, TC1767, TC1782, TC1792, TC1793, TC1796, TC1797.
ECU:
|
|
Attention! Read before purchasing:
Module works only with Scanmatik SM2 or SM2 Pro.
This FID is not suitable for cloning ECU because there are protected OTP sectors. Also sectors (0x10; 0x20) are skipped during writing operation in order to avoid bricking ECUs.
On some ECUs checksums calculation may take a long time. It depends on the configuration of your computer.
In case of an identification error, check your connection, and also change the places of the GPT wire.
All tested adapters with automatic power management with wires for the GPT signal output available.
For module operation, the purchase of a Bitbox USB protection key is required.
Activation of modules is performed within 1 hour on business days (usually 10-15 minutes). Activation may be delayed on weekends and public holidays (up to 2 hours).
To activate the module, only the serial number of the key and email are required.
To connect the control unit on the workbench, the purchase of additional equipment is required, any of the following:
Powerbox and Combibox for PCMflash are fully compatible with Bitbox.
An activated module or license cannot be returned.
If you have entered the wrong key or device number, the return is not valid. It is not possible to modify the license for another device.
After status update to "Waiting for activation", the data has already been sent to the developer for activation. The order cannot be canceled or corrected starting from this status update.
Pay attention to all information specified in the description of modules and scripts taken from the manufacturer. We are not responsible if the information is not correct or there are some differences from the reality. In the disputed situation, it is necessary to look for a solution to the issue to the manufacturer.
Our store is not responsible for the functionality of the software module. We cannot guarantee the declared functions since we are not the developer.