MOTO Delphi MT05 BitEdit module

Module for calibrating firmware of Delphi MT05, MT05.2, MT05.3 control units used in various types of motorcycles.

Available for modification (MT05.2 and MT05.3 FLASH 128 and 256 Kb blocks)

Air calculation: filling with base air, volumetric efficiency at idle, volumetric efficiency at partial load, volumetric efficiency correction through PAtm, throttle position for full load entry
Idle speed: additional correction for idle injection, additive correction of idle speed after start, desired idle speed rotation frequency, idle spark advance, target lambda value at idle, target lambda value at idle
Lambda: Target lambda at full load, Target lambda at partial load, Lambda correction based on coolant temperature, Throttle position for switching to lambda map at full load, Normal stoichiometric A/F (lambda=1)
Limiters, IF DETECTED!: Engine speed limitation, Engine speed limitation recovery, Vehicle speed limitation, Vehicle speed limitation recovery
Scaling: Scaling of coolant temperature sensor, Scaling of intake air temperature sensor, Throttle position sensor in case of malfunction, ADC voltage for TPS high circuit malfunction detection, ADC voltage for TPS low circuit malfunction detection, Injector scaling
Spark advance: Spark advance delay time at full load, Spark advance delay time at partial load, Base spark advance, Coolant temperature-based spark advance correction, Intake temperature-based spark advance correction, Maximum delay time
Start: Idle actuator position during start, Spark advance during start, Desired lambda value during start
Diagnostic trouble code mask

Available for modification (MT05.3 FLASH 1.5Mb blocks)

Air calculation: map for calculating nominal charge, volumetric efficiency, volumetric efficiency correction through PAtm
Correction: Temperature-based injector correction
Fuel: Enrichment
Idle speed: Engine rotation frequency at idle depending on temperature, Spark advance during start
Lambda: Lambda at idle based on temperature, Lambda at fully open throttle, Lambda ta at idle based on pressure, Normal stoichiometric A/F (lambda=1), Target lambda at partial load
Limiters: Engine speed limitation, Vehicle speed limitation
Scaling: Scaling of coolant temperature sensor, Scaling of intake air temperature sensor, Throttle position sensor in case of malfunction
Spark advance: Delay time, maximum delay time, spark advance correction, spark advance during full load entry, spark advance at idle based on temperature, spark advance during partial load, spark advance characteristics map, spark advance correction based on coolant temperature, spark advance correction using intake temperature, spark advance during start based on temperature

To use the module, you need to purchase a BitEdit USB protection key BitEdit. The key can be purchased in our store. An unlimited number of modules can be purchased for one key.

Updates of descriptions for new software versions within the module are free.

Module activation is performed within 1 hour on business days (usually 10-15 minutes). Activation may be delayed on weekends and holidays (up to 2 hours). 

Only the serial number of the key and email are required to activate the module.