Module for calibrating firmware of Bosch MSE6.0/US6.0 control units used in various types of motorcycles.
Available for modification
Air control: correction of air mass flow pulsation in additional mode
Air mass calculation: air mass flow through throttle valve, absolute pressure in the manifold in case of sensor error, calculated target air filling, throttle valve position based on air mass flow
Air mass calculation: efficiency: residual exhaust gas pressure, volumetric efficiency
Exhaust gas model: Exhaust gas temperature in additional mode
Idle speed control: desired idle speed, desired idle speed during warm-up, increased idle speed depending on battery voltage
Injector control: Injection end time, Injection end time at full load, Injection end time at startup, Injection end time based on engine speed, Injection end time at cold engine, Injector idle time, Injector constant flow rate
Limiters: engine speed limit, vehicle speed limit (check if found, not guaranteed)
Ignition advance: optimal ignition advance, base ignition advance, ignition advance correction depending on coolant temperature
Startup: Cold start enrichment, Injection correction coefficient to reduce enrichment during cold start, Injection correction coefficient to reduce enrichment during warm start, Enrichment during warm start
Target lambda: lambda configuration bitmask (0 - no lambda, 1 - front, 3 - both), lambda limit for combustion, lean lambda threshold based on coolant temperature, pulsation correction coefficient, target lambda at full load, target lambda at partial load, target lambda during warm-up, target lambda during hot engine acceleration
Diagnostic trouble code mask
To use the module, you need to purchase a USB protection key BitEdit. The key can be purchased in our store. An unlimited number of modules can be purchased for one key.
Updates of descriptions for new software versions within the module are free.
Module activation is done within 1 hour on business days (usually 10-15 minutes). Activation may be delayed on weekends and holidays (up to 2 hours).
ONLY the serial number of the key and email are required to activate the module.
An activated module or license cannot be returned.
If you have entered the wrong key or device number, the return is not valid. It is not possible to modify the license for another device.
After status update to "Waiting for activation", the data has already been sent to the developer for activation. The order cannot be canceled or corrected starting from this status update.
Pay attention to all information specified in the description of modules and scripts taken from the manufacturer. We are not responsible if the information is not correct or there are some differences from the reality. In the disputed situation, it is necessary to look for a solution to the issue to the manufacturer.
Our store is not responsible for the functionality of the software module. We cannot guarantee the declared functions since we are not the developer.
