Bosch MSE9.0 Module for BitEdit — Professional ECU Calibration Tool
The Bosch MSE9.0 Module for BitEdit is designed for editing and calibration of ECU firmware used in Bosch MSE9.0 engine control units. It supports a wide range of motorcycles, ATVs, and other types of power sports vehicles.
Ideal for ECU tuning professionals, engineers, and enthusiasts using BitEdit software.
To activate the module you need a USB key BitBox/BitEdit. When ordering, please indicate the Serial Number of the key.
Key Features
- Supports 6MB firmware files
- Works with Flash 0 and Flash 1 maps
- Enables precise calibration of key engine parameters
Editable Maps
- Air Calculation: Inversed pedal characteristic map, mass air flow through throttle valve at idle, target air filling, air intake temperature correction factor.
- Dwell: Coil charge time control (Dwell Time).
- Engine Speed Limitation: RPM limitation in additional operating modes.
- Fan Control: Fan control sensor settings and temperature thresholds.
- Fuel: Acceleration and deceleration enrichment factors, warm-up enrichment, post-start enrichment, and temperature correction factors.
- Lambda: Lambda for component protection, lambda efficiency, target lambda at full load.
- Spark Advance: Minimum and optimal spark advance, ignition angle, and efficiency by delta ignition angle.
- Temperature: Exhaust gas temperature management.
- Throttle Control: Mass air flow through throttle valve control, maximum throttle position.
- Torque: Engine drag loss torque, optimum torque, and torque limitation.
- Vehicle Speed (if found): Vehicle speed limiters (when available in firmware).
Advantages
- Full support of Bosch MSE9.0 original calibrations
- Seamless integration with BitEdit software
- Intuitive interface for quick and precise ECU tuning
- Ideal for motorcycle performance optimization and professional tuning workshops
An activated module or license cannot be returned.
If you have entered the wrong key or device number, the return is not valid. It is not possible to modify the license for another device.
After status update to "Waiting for activation", the data has already been sent to the developer for activation. The order cannot be canceled or corrected starting from this status update.
Pay attention to all information specified in the description of modules and scripts taken from the manufacturer. We are not responsible if the information is not correct or there are some differences from the reality. In the disputed situation, it is necessary to look for a solution to the issue to the manufacturer.
Our store is not responsible for the functionality of the software module. We cannot guarantee the declared functions since we are not the developer.