SVEdit USB dongle

Hardware dongle key is used to protect SV Edit software from hacking and unauthorised access

The S&V EDIT program is used for editing control unit firmware. Editing is necessary for chip tuning and disabling engine components. The main advantage of the program is its ease of use, most functions can be performed with a single button press, deep knowledge is not required. Single-button implementation also saves a lot of time.

Attention! The key is not sold without a module! You must add at least one module to your order. Orders without module will be cancelled. The money transfer fee may be lost.

Main features of SVEdit program:

• disabling the catalyst, disabling lambda probes control after the catalyst (CAT OFF)
• disabling the exhaust gas recirculation system (EGR OFF)
• disabling the immobiliser system (IMMO OFF)
• disabling the Adblue urea injection system (ADBLUE_SCR OFF)
• disabling the diesel particulate filter in diesel cars (DPF OFF, FAP OFF)
• disabling fault codes (DTC OFF)
• deleting Readiness Codes
• disabling the petrol vapor capture system (EVAP OFF)
• editing information and functions in EEPROM blocks EDC17, MED17, PCR2.1, BCM2 Audi, Passat CCM
• calculating CRC checksum (CHECKSUM)
• increasing power to Stage 1, Stage 2 levels

The program has a modular system. To open a module, you need to purchase a license. To open a module, the purchase of a USB key is required.

If the USB key is lost, the modules cannot be restored. Activation of software modules is done within an hour during working hours, there may be a delay during non-working hours.

To use the USB key, you need to install the driver SenseLock EL4-Genii. Download Senselock driver from the official website.

You can buy S&V edit modules in our iobd store.