Script for BCM (UCH) units produced by Johnson Control via OBD2, or CAN bus connector.
These units are installed in a wide range of cars. From Lada XRay, to Renault Logan2, Daster2, Sandero2, Nissan Terrano2, as well as Smart
For owners of IProg PRO
Supported OBD2 functions:
Block identification, FLASH memory read-write, EEPROM reading
When working with Flash memory. Reading, writing, and checksum verification of the read!
Functions allowing to work with key information. Reading and changing VIN code, Reading IDN and PIN codes.
As well as code sequence (KEY) for preparing a Master key in case of complete key loss.
Reading programmed key codes. Possibility of immobilizer reset (Virgin).
Direct conversion from ISK code to PIN code!
Block errors reset.
Key writing (up to 4 pieces).
Work is possible even with complete key loss! Binding a prepared key while maintaining synchronization with the ECU.
The script works with all OBD adapters (CAN)
Work is possible both in the car and on the table. Connection diagram on the table is attached.
Comprehensive documentation for working with the script is provided. IMPORTANT! Working with the block is quite responsible! Everything that is possible I protected from user errors, But work with the block ONLY STRICTLY ACCORDING TO THE INSTRUCTIONS!
Sequence of actions for its various uses.
Open the program and click “Help” -> “About”.
Copy data from the program when placing an order
After completing the order, you will receive files, they must be added to the Scripts folder..
Launch the program and on the left side of the screen you will see the added scripts.
An activated module or license cannot be returned.
If you have entered the wrong key or device number, the return is not valid. It is not possible to modify the license for another device.
After status update to "Waiting for activation", the data has already been sent to the developer for activation. The order cannot be canceled or corrected starting from this status update.
Pay attention to all information specified in the description of modules and scripts taken from the manufacturer. We are not responsible if the information is not correct or there are some differences from the reality. In the disputed situation, it is necessary to look for a solution to the issue to the manufacturer.
Our store is not responsible for the functionality of the software module. We cannot guarantee the declared functions since we are not the developer.